BLINDO + HPC
HARD RESIN CLEAR BASE COAT
#Blindo Plus is a new coating concept: it creates an ultra-fine, transparent layer that increases the hydrophobic properties of the surface and is more resistant to the adhesion of salt deposits (limestone) and to the action of corrosive agents (rain, salts, detergents, etc.). It also has greater chemical stability for improved durability over time.
#HPC opens the way to a new category of overcoat coatings. Thanks to its nano hydro-gel system technology it creates a hydrophobic membrane with a polymeric matrix consisting of “building blocks” that crosslink and anchor directly on the surface at room temperature, generating a very resistant and elastic layer.
#HPC cannot be purchased separately

How to use:
SURFACE PREPARATION :
An accurate preparation of the surface to be treated is essential for the correct fixing and maintenance of the coating. We recommend that you always observe these simple rules:
• the surface must be decontaminated and free from any residue;
• remove old waxes, sealants or coatings from the surface before proceeding;
• the surface must be perfectly free from scratches superficial , marks and stains which, if present, must be removed with a polisher;
• if you are working with a new car that does not require corrective paint work , proceed with a decontaminating wash to remove any residues from transport;
• the bodywork must be completely degreased : use # VÈRITAS in the dilution 1: 5 before applying the coating. This step is mandatory!
SUGGESTIONS FOR APPLICATION :
Always apply the coating in covered and dust-free environments , never outdoors. We recommend the use of PPE (Personal Protective Equipment) in this case the solvent vapor mask. Never work in direct sunlight. Make sure the work area is well ventilated. There are two main factors that influence the application of coatings: temperature and humidity . The higher the temperature and / or humidity, the shorter the coating time will be. We recommend working on small sections of maximum 50x50cm. It is essential to use correct lighting. Apply the coating using reflected lights. Point your light towards the wall or ceiling – this will help you spot possible burrs that you will need to remove immediately. The initial fixing time of the #BLINDO PLUS and #HPC coatings of #Labocosmetica with the treated surface is a few minutes: then use microfibre cloths to eliminate residues and carry out the finishing. Make sure that the car remains in optimal conditions without the risk of rain or sudden changes in humidity: the curing time necessary to allow the partial closure of the coating takes place within 12 hours, while the total one takes place within 36 hours and it is advisable not to wash the car for the first 7/10 days . If you have an infrared lamp, place it at a distance of 50cm for about 15-20 minutes at a temperature of 60 ° C to fix the coating to the surface. Always respect the application instructions of the individual products.